When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2 Set 385311462 385310677 RV Toilet Seal Kit for Dometic Sealand 110 111 210 510: $13.36
2 Sets385311462 385310677 RV Toilet Seal Kit Compatible with Dometic Sealand Vacuflush 110 111 210 510 Flush Toilets - Without Overflow Holes
PRODUCT INTRODUCTION
PRODUCT SPECIFICATIONPackage Includes - 2 X 385311462 RV Toilet Seal + 2 X 385310677 RV Toilet Seal
Dometic / Sealand:506+, 511H, 547+, 548+, 706, 709, 748, 749, 806, 808, 847, 848, 1147, 1148, 2010, 2011, 5006, 5047VacuFlush168, 606, 647, 648, 1006, 1008, 1047, 1048,1049, 1106, 5146, 5148, 5149
Heavy Duty glass reinforced plastic ring with elevated channel aligns perfectly with black seal preventing misalignment of seals during the installation processThis sealand toilet part is made of high quality rubber well tested by the manufacturer, with higher efficiency, duribility and the best quality for a longer service life and meets OEM standardsIf you need Dometic 300, 310, 320 series toilet accessories, please don't buy this item, you should buy 385311658 Flush Ball Seal KitTo Ensure Safe And Secure Installation, Please Observe The Instructions Below
- Turn off the water switch.Press the flush pedal to drain water from the toilet
- Lose the stainless steel strip and remove the plastic half clamp to connect the porcelain and plastic base
- Tilt the porcelain bowl forward, grab the vacuum breaker attached to the back of the toilet, and pull it out of the toilet. Put the toilet aside
- Remove original kit.Check flush balls for gaps, scratches or mineral deposits. Cleaning or replacement as necessary
- Place the large plastic disc on the top of the thin seal, through a ring of thin seal raised in the center of the large disc
- Place seal and disk assembly on top of flush ball
- Place the porcelain back on the toilet base, align the notch with the pin on the base, and align the bowl outlet with the flush ball. Then insert the vacuum breaker into the back toilet and push it into the rubber seal ring
- Reinstall plastic half clip under loose steel strip, tighten stainless steel clamp
- Reinstall pedestal cover, turn on water
|