2 X LED Switchback, Daytime Running / Turn Signal Strip Lights, For Sale - New and Used

DREAM LEDDESCRIPTION

2 LED Switchback / Dual-Color Light Strips – One Pair

High-output flexible LED strips designed for use as daytime running lights, turn signals, marker lights, accent lighting and other custom 12V lighting applications.

AVAILABLE COLOR COMBINATIONS

• Amber / White

• Amber / Red

• Red / Red

• Yellow / Yellow

• White / White

AVAILABLE LENGTHS

Choose your required length from the drop-down menu:

4" | 8" | 12" | 16" | 20" | 24" | 28" | 32" | 36" | 48"

This listing is for TWO LED strips of the selected length and color combination.

DETAIL SPEC. & FEATURES

• Dual-color LED strip design

• High-output 5050 SMD 3-chip LEDs

• Flexible, thin-profile construction

• Waterproof LED strip

• Approximately 12V DC operating voltage

• Fast, instant illumination

• Long LED service life

• Black strip surface for a clean adhesive backing

• Supplied with power wires

• Multiple lengths and color combinations available

The dual-color versions allow two separate lighting functions from the same LED strip.

For example, with Amber / White, the white circuit can be connected as a daytime running or marker light while the amber circuit can be connected to the vehicle's turn-signal circuit.

Other color combinations can be used for custom applications depending on your vehicle and installation requirements.

POSSIBLE APPLICATIONS

These LED strips can be used for many 12V lighting applications, including:

• Daytime Running Lights (DRL)

• Turn Signals / Indicators

• Parking Lights

• Marker Lights

• Headlight Accent Lighting

• Tail Light Accent Lighting

• Golf Cart Lighting

• Motorcycle Lighting

• ATV / UTV Lighting

• Custom Automotive Lighting

IMPORTANT – 12 VOLT POWER

These LED strips are designed to operate from a 12V DC power source.

For golf carts or other vehicles using a 36V or 48V electrical system, a suitable 12V step-down voltage converter/reducer is required. (Ask for details)

DO NOT connect these LED strips directly to a 36V or 48V power source.

INSTALLATION

Professional installation is recommended.

Always test each LED strip BEFORE permanently installing it.

1. Temporarily connect the LED strip to a suitable 12V power source and verify correct operation.

2. Determine the final mounting position and route the wiring before attaching the strip.

3. Make sure wiring will not contact moving parts, sharp edges or direct heat sources.

4. Thoroughly clean the mounting surface with alcohol and allow it to dry completely. The surface must be free of oil, wax, dirt and moisture.

5. For maximum adhesion, 3M™ Adhesion Promoter is recommended. Adhesion promoter is not included unless specifically stated in the listing.

6. Carefully apply the LED strip using the supplied adhesive backing. Do not aggressively rub or press directly on the LED components or silicone covering.

7. Allow sufficient time for the adhesive to bond before placing stress on the strip.

8. Route and secure all wiring. If the supplied wires need to be extended, use suitable automotive-grade wire and properly insulated connections.

CUTTING THE LED STRIPS

Standard LED strips may be shortened ONLY at the designated copper cutting points.

Do not cut anywhere other than the marked cutting locations.

Cutting the strip incorrectly can permanently damage the strip.

Sequential/running LED strips must not be cut unless specifically stated otherwise.

PLEASE NOTE

Installation damage, incorrect voltage, cutting the strip at an incorrect location, physical damage to the LEDs/silicone, or damage caused by improper installation is not considered a product defect.

Please test the strips before installation. Removing an LED strip after it has been permanently installed can damage the strip.

WHAT YOU RECEIVE

• 2 × LED Light Strips in your selected length/color combination

• Attached power wiring

• Double-sided adhesive backing

Please select your required LENGTH and COLOR from the drop-down menus before purchasing.

---