Step 1.Measure the size of the car glass, the length and width of each one plus more than 3 cm, so as not to install the film does not conform to size.
Step 2.A clean window is vital a successful factor,so keep window or glass clean.
Step 3. Remove the transparent backing sheet from Film .Cover the surface of the whole film with water.This helps to prevent the film becoming tangled and sticking to itself.
Step 4. Pick your film up and apply to your window( Please MAKE SURE you have removed the backing sheet before you apply to the window and glass).
Soap and water on film and glass can make it slide to the correct position.
Step 5. And repeat scraper process,using the scraper to push any remaining moisture or bubbles to the edge of the window.Much easier than Wall Decals.
Step 6. Finally use the paper towels to dry the window and the frame,being carefully not to lift the film at the edges or corners.
3. Visible Light Transmittance rate （VLT）: 75%
4. UV protection (UVR):99%
5.Film Thickness2mil
Packing Includes:
1 Roll Car Window Film
