Dana Spicer drive shaft one piece aluminum 2005 - 2010 Mustang GT V8 # 10001766 For Sale - New and Used

Dealership inventory reduction. This brand new Dana Spicer performance one pieces aluminum drive shaft is brand new but has a scuff(photo 2) caused during shipping so we are discounting it well below the manufacturer price at only $475. Shipping is $55 due to the length and weight of this part. See second photo for the scuff. Dana part number 10001766. Specifications are listed below.

Mustang Performance Drive Shaft - Aluminum 3.5 inch Diameter 1350 Series 1312 mm

Unleash the performance in your Ford Mustang with the Spicer one-piece aluminum driveshaft. Engineered specifically to enhance driveline performance in high horse power applications our design yields peak performance and optimum strength. Our reduced weight design is on average 21 pounds lighter than the OE shaft yielding reduced rotating mass, improved driving performance and quicker acceleration. The one-piece design eliminates the need for a center bearing further reducing driveline weight. This direct bolt-in assembly mounts directly the OE flange and requires no adapters. Spicer parts are engineered for peak performance so hit the road with confidence knowing you are backed by the global leader in driveline technology.

• 1336 mm (52.598 inches) Overall Length....face of transmission flange to face of rear end flange dimension
• Direct BOLTIN right out of the box
• Designed for Increased Horsepower applications to deliver peak endurance and optimum strength
• 3.5 inch Diameter .125 inch wall thickness 6061-T6 aluminum tubing
• 1350 SERIES Dana Spicer 5-1350X Universal Joints...much stronger than the 1330 series versions available for Mustangs
• Comes with 1350 series flange yoke to bolt to transmission
• Comes with 1350 series flange yoke to bolt to OE Mustang rear end flange...NO adaptor required
• Fully Assembled and Balanced
• Spline and Slip design to allow for installation and suspension movement
• Hard Plastic boot to keep grease in and water out to protect spline and slip from contaminants
• Reduces noise, vibration and harshness in your Mustang driveline
• Eliminates the need for a center support bearing
• Lighter Weight than OE Driveshaft - Reduces overall weight and rotating mass
• Delivers improved driving performance
• Provides quicker acceleration and faster ET at the track

• Fits FORD MUSTANGGT with V8 engine 2005, 2006, 2007, 2008, 2009 and 2010
• 1350 Series for extra strength and reliability
• 3.5 inch Diameter .125 inch wall thickness 6061-T6 aluminum tubing
• 1336 mm (52.598 inches) Overall Length....face of transmission flange to face of rear end flange dimension
• Direct BOLTIN right out of the box

---