Bosch Diesel Fuel Injector Fits For 2007-2012 Cummins Dodge Ram 2500 3500 6.7L 1
126.06 USD
Free shipping
BOSCH DIESEL COMMON RAIL FUEL INJECTOR Fits ForDODGE RAM CUMMINS 04-09 5.9L 1X
126.57 USD
Free shipping
Cummins 6 pcs Injector Connector Tubes Fits for 1998-2002 Dodge 5.9L 24V 3944833
60.75 USD
63.95 USD
Free shipping
5%
offAC Button Repair Kit Dash Replacement For 2007-2013 GM Vehicles Decal Stickers
6.7 USD
Free shipping
2pcs SHITBOX EDITION Chrome Metal Emblem Decal Badge Stickers for GM Truck 3D
5.33 USD
9.04 USD
Free shipping
41%
offMini USB LED Interior Light Atmosphere Ambient Lamp Car Accessories Ice Blue
2.12 USD
3.03 USD
Free shipping
30%
off
Fuck-IT Edition 3D Emblem Badge Decals for Universal Car Truck (Black White) 2PC
Specification:
Condition: 100% Brand New
Color: Black
Material: Zinc Alloy
Item Weight:0.02 lb
Package Dimensions:5.24 x 3.5 x 0.55 inches
Features:
MATERIAL-Made of high-quality 3D high-quality ABS plastic. It has good depth and bevel, and is strong. High-quality outdoor materials can withstand all weather conditions, are durable and waterproof
EXQUISITE CRAFTSMANSHIP-Superb laser cutting design, the edge of the emblem is smooth and does not hurt your hands.The back of the sticker is made of car-specific double-sided tape
EASY INSTALLATION-No tools needed. can be applied to any clean flat surface -vehicles, car doors, car body ,car side fender ,car rear trunk , etc
Installation Instructions:
1.Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper.
2.Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag.
3.Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry.
4.Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body lines. Use painter’s tape to make your guide lines.
5.Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after Remove the backing tape from the adhesive.
6.Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located properly.
7.Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually takes 10 seconds.
What you get:
2 xFuck-IT Edition car badge sticker