This is anLED upgrade KitforYOURswitches.
You areNOT buying new switcheswith LED\'s but a kit to upgrade your OEM switches/controls and gauges to LED\'s.
This is aDo-it-YourselfSteering Wheel Switch bulb to LED Upgrade Kit.
Soldering skills are necessary for this kit.
The kit includes the led\'s for every switch in your truck!!!
This includes the instrument cluster, all climate control switches, all window switches, the homelink buttons, the rear view mirror, the headlight and dimmer switch, the fog light switch set, the 4wd switches, the rear radio controller, everything that uses an LED in your truck!
These are fully dimmable 360 LED High Performance LED\'s.
I personally designed and manufacturedthese LED\'s for GM vehicles.
They are the ONLY LED\'s in the WORLD that come with a LIFETIME WARRANTY and can handle the voltage highs and lows that are demanded by GM vehicles.They will NOT flicker or burn out!
NO ONE else in the world has these LED\'s for sale.
My LED\'s are square, not round so they emit light 360 degrees around them evenly and consistently. There are no bright/hot spots when you use 360 LED\'s.
These LED\'s run brighter, demand less power, and run cool to the touch protecting your circuit boards for years to come.
Just remove the old bulbs/led\'s from the circuit boards and solder the new LED\'s in place.
PURE BLUEEMERALD GREEN,RUBY RED,ULTRA BRIGHT WHITE,GOLDEN YELLOW,PASSIONATE PINK,ULTRA-VIOLET PURPLE,ICE BLUE,RAINBOWRED,WHITE, &BLUE
I\'ve searched the internet, and high and low for a complete kit for the entire truck and I couldn\'t find any.
Then when I added up all of the kits I could find to get a half set that covered the cluster, climate control, and door switches, it was well over $300!!!
There is no reason in the world that anyone should have to pay that much for LED\'s!!!
I will be sending you more than enough to complete your job and you\'ll still have some left over for other projects!
TIPS:The LED\'s have two legs. One is longer than the other. The longer leg is the positive leg. These LED\'s are polarity sensitive.
The easiest way to do this without a bench test harness is to take the unit apart plug it in to the truck while apart.
Use your multi-meter to determine positive and negative and mark it on the circuit board with a marker. If you don\'t have a multi-meter, you can also use a continuity tester or one of the led\'s.
Once you have marked the polarity, unplug your unit from the truck, solder in the new bulbs, assemble, install.
There are Youtube videos that will walk you through this install. I highly recommend you watch one.. or more.
If you run into problems that Youtube can\'t fix, just email me.
My photos (All photos used in this listing) are my intellectual property.
They are watermarked, copyright protected, they are not for sale, and I will prosecute unlawful use and theft of them to the fullest extent of the law.
Regardless of the compatibility chart,
If the switches look like the ones in your current GM vehicle, they will work.
Vehicle Compatibility:
2003-2007
Chevrolet Silverado 1500,2500 & 3500
2003-2007
GMC Sierra 1500,2500 & 3500
2003-2006
Chevrolet Avalanche - All
2003-2006
Chevrolet Suburban - All
2003-2006
Chevrolet Tahoe
2003-2006
GMC Yukon
2003-2006
Cadillac Escalade
2003-2007
Hummer H2
2004-2005
Buick Rainer
2004-2009
Chevrolet Trailblazer
2004-2009
GMC Envoy
2004
Oldsmobile Bravada
No refunds, no returns!
