MAF Racing LLC.
MAF acing Bumper Support
Racing bumper support ONLY HEAT EXCHAGER IS NOT INCLUDED
Our GT-500 front bumper has special mounting brackets that can be used to mount the a AFCO, Department of Boost, VMP and Lightning Force Performance heat exchangers. This a direct bolt on for 99-04 mustangs. All of these bumpers use the HD 1.5" main tubing. Bumper cover may require slight notching to clear the bottom of the heat exchanger in non Afco installs.
••••off road use only••••
Docol R8 Tube ? Ultra High Strength Steel ? Dual Phase Steel
Weight is 6lb 7oz for the heavy duty bar that provides more front end crash protection.
BOLT ON with common hand tools. some years will require drilling 4 holes.
These are offered to fit Ford Mustangs from 99-04
TIG Welded
Unpainted
MADE IN THE USA
Free shipping in the USA
These bumpers are built to order so shipping is 1-2 days
When you order be sure to specify what year car you have.Incorrect year will have fitment problems.
Message us if you are unsure of the year of the car.
Docol R8 was engineered to provide a stronger, more consistent alternative to 4130
Suitable applications: aerotube, roll cages, chassis, suspension, wheelie bars, motorcycles, wing struts, drive shafts, nerf bars and bumpers.
Common production car applications: door crash bars, roof bows, A&B pillars, bumpers, foot boxes and seats. Docol has been used in production cars for more than 30 years.
Currently allowed for:
NHRA Top Fuel and Nitro Funny Cars ? SFI Spec 2.3 & 10.5
NHRA Full Bodied Cars ? SFI Spec 25.x Pro Stock, Pro Mod, Pro Street
KEY ADVANTAGES OF DOCOL R8
- Stronger than 4130 by 10 to 15 percent
- Heat Affected Zone (HAZ) in Docol R8 is much less in area than 4130, less brittle than 4130, retains better elongation and necking than 4130
- Docol R8 is much more tolerant to heavy fabrication
- clean mill finish product ? minimal, if any, surface prep required
- Accurate and consistent dimensional and mechanical properties due to this material being a rolled and welded strip.
- Compatible with welding to 4130 and mild steel
- Use ER 80 S filler material (same as 4130)
- Suitable for TIG and MIG welding
