This is a new aftermarket 06-11 style gauge cluster that has been modified to work on any 2002-2005 Sea-Doo 4-tec model. This display is plug and play. No programming required.
You will simply need to remove your old cluster and harness and plug this one in with the supplied harness to where the original cluster harness plugs in behind the front storage cover in the front storage compartment.
You will need to drill two small holes and trim the area around the old cluster for install.
NOTE: The warning lights look like they flicker in the video, but this is only due to recorded frame rate. There is no flickering in person.
You will receive the following:
- New Gauge Cluster
- New Bezel
- Wire Harness
- Install Manual
Cluster will display temp in either Celsius or Fahrenheit depending on stock received from our supplier.
PLEASE NOTE:Each cluster is tested for 100% functionality before shipping. Please make sure that your wiring to the cluster is good by checking for power and for signal to your original 4-pin plug located behind the front cover in the storage compartment.
If you receive a cluster that does not work, we will test it upon return and send you a replacement if found to be defective at no cost. If the returned cluster is 100% functioning, or you are wanting a refund in place of a replacement, then the following money back policy applies.
Money Back Policy: If returning for any other reason besides defective (i.e. change of mind, your ski wiring/ecu/MPEM is your issue, ETC) the original shipping cost, return shipping cost and a 25% re-stocking fee will be deducted from the refund amount. If returned cluster shows signs of use a deduction up to 50% may be taken from the refund.
