4M/13Ft Z Shape Rear Window Rubber Seal Weather Strip Car Door Seal Protector For Sale - New and Used

4M/13ft Z Shape Car Window Door Rubber Seal Strip Edge Trim Guard Weatherstrip for Car Window Door Engine Cover

Descriptions:

• High Quality Rubber: The Car Door Seal Strip is made of high grade rubber, good flexibility and resistance to compression, resistance to aging, very durable and sturdy in using

• Reduce Door Impact: Installing the sealing strip can well reduce the impact of the door, making the door open and close sound steady and thick, with the role of buffering the door, shock absorbing and protecting the glass

• Dustproof and waterproof improvement of interior sound field: Z shape design. Improve the effect of dustproof, waterproof and heat insulation inside the car; Improve cooling and heating efficiency of air conditioning; Improve the interior sound field, improve the effect

• Optimize engine heat dissipation and reduce fuel consumption: The sealing strip can effectively optimize the heat dissipation airflow in the engine cabin, reduce fuel consumption and keep the engine clean, greatly reducing the dust into the car

• Strong Adhesive for Easy Install: With adhesive tape behind, very easy to install without using tools; Direct replacement tape, you just need to push the stripping foam on the rubber sealant above the installed place; Can be installed on side of car doors, door frame and window, helping to lower the wind and the sound of vibration, prevent chips, knocks, scratches, etc

Features:

• Length: 4m (157inch)

• Style: Z Shape
  

• Color: Black
  

• Material: EPDM Rubber + Adhesive

• Fitment: Universal for cars

Package Include:

• 4M/13FT Rubber Seal Weather Strip

Installation Method:

• 1: The body must take before pasting paste parts deal with clean, do not have any stains and moisture.

• 2: After pasting to keep clean, do not suffer long against dirt and water, otherwise it will lose tack 3M tape effect, there will be off open plastic phenomenon.

• 3: Paste selected bits identify the paste will start from the front side door seal the lower end of the rod began to carry out a little pressed paste, be careful not to pull the seal a little action, try to keep the prototype seal slowly aligned identify the Paste the path carefully paste; position in the corner of the door frame, seal very gentle to pay attention to bend away type, do not bend too fast aesthetic impact. Figure fast not seek hurry, so as to ensure results.

• 4: All pasted into After the check, after a while the time were thoughtful and meticulous hand pressing it, you can call it a day, and this time it is best not to close, wide open doors on 20 minutes after a closed door, Then the best other 3 - 5 hours before normal use to open the door.

• 5: Complete ban after pasting a hand to pull the seal ban car washing water on in three days as much as possible not to repeatedly switch the door within 24 hours.

• 6: Construction of close will be a little tight, please do not worry, in the first 2-3 days when you can normal.

• 7: Please everyone in 1-2 days time more attention to the door is not closed, safety
  

  

  ---