Bee*R Rev Limiter Type B Launch Control Fire Thrower Racing Ignition Cut For Sale - New and Used

Rev Limiter Launch Control Ignition Cut ControllerUniversal 12V Racing Controller For Custom Performance ApplicationsProduct FeaturesImportant WarningThis is a universal performance modification controller, not a direct factory replacement part. Professional installation and proper wiring are required. Incorrect wiring may damage the ECU, ignition system, engine components or electrical system. Off-road / racing use only. Please check local laws before installation or use.

• Universal rev limiter and launch control style ignition cut controller.
• Designed for custom racing, drift, track and performance modification applications.
• Adjustable control knobs allow RPM limit and gain adjustment depending on setup.
• Can be used as a 2-step style launch control controller when correctly wired and tuned.
• Ignition cut operation may create an aggressive exhaust sound or flame effect on some modified vehicles.
• Fire / flame effect is not guaranteed and depends on vehicle setup, exhaust system, fuel system and tuning.
• Suitable for many 4-cylinder, 6-cylinder and rotary engine custom applications when properly wired.
• Not a plug-and-play part. Vehicle wiring verification is required before installation.
• Package includes 1 controller with wiring harness and included accessories as shown.

Condition100% Brand NewProduct TypeRev Limiter / Launch Control / Ignition Cut ControllerVoltage12V vehicle electrical systemApplicationUniversal performance / custom wiring applicationMaterialABS plastic housing, electronic componentsPackage Includes1 x Controller with wiring harness and accessories as shownInstallation InstructionsProfessional Installation RequiredThis controller requires custom wiring into the vehicle ignition / RPM signal system. Installation should be performed only by a qualified performance technician familiar with vehicle electrical systems and engine management wiring.

• Verify that your vehicle uses a compatible ignition and engine control system before installation.
• Do not install by guessing wire colors. Confirm all wiring with a service manual or professional wiring diagram.
• Disconnect the vehicle battery before any wiring work.
• Mount the controller in a dry and secure location away from heat, water and moving parts.
• Route all wiring away from exhaust heat, sharp edges, belts, pulleys and steering components.
• Do not operate the vehicle if wiring is loose, exposed, shorted or incorrectly connected.
• After installation, settings must be adjusted carefully according to the vehicle setup.
• Incorrect RPM limit, gain setting or wiring may cause misfire, check engine light, ECU damage or engine damage.
• Use only for racing, drift, track or off-road custom applications where TypeFitment NoteUniversal Custom Racing Application4-cylinder engineCustom wiring and compatibility verification requiredUniversal Custom Racing Application6-cylinder engineCustom wiring and compatibility verification requiredUniversal Custom Racing ApplicationRotary engineCustom wiring and compatibility verification requiredFitment is universal for custom performance use only. This item is not vehicle-specific and is not a direct replacement part. Please confirm vehicle wiring, ignition type, ECU compatibility and local regulations before purchase.
  
  

  ---