For 2011-2015 Volkswagen Touareg 7P Liftgate Lift Supports 7P6827851H For Sale - New and Used

OE Number：7P6827851D

Will fit Following Models

• Fit：Volkswagen Touareg 7P 4 Door Material, Built to Last:Made from high-strength stainless steel, this robust structure resists deformation and ensures a long service life, giving you peace of mind.
• Powerful Performance, Smooth Operation:As the core actuator of the electric tailgate system, it delivers ample power to ensure the tailgate lifts smoothly, quietly, and without any sticking.
• Perfect Fit, Direct Replacement: Specifically developed for the Volkswagen Touareg 7P 4 Door 2011-2015models. Precisely customized based on original vehicle data for perfect compatibility, allowing for a direct and easy installation.

INSTALLATION INSTRUCTIONS

• Ensure Safety
  If you need to work under the vehicle, be sure to use safety stands to support the vehicle. Otherwise, have someone hold the hood/tailgate open for you so that the opening angle can be adjusted as needed.

• Verify Before Removal
  Before removing the old lift support, check the type of end connectors and the extended length to ensure they match the mounting ball studs and specifications on your vehicle.

• Remove the Old Lift Support
  Use a small flat-head screwdriver to insert it under the U-shaped spring clip at the end of the support. Gently twist the screwdriver to lift the clip approximately 3 mm, then pull the support off the ball stud to remove it.

• Install the New Lift Support
  Follow the reverse steps of removal.Important: Do not force the end of the new lift support onto the ball stud without slightly lifting the U-shaped spring clip, as this may cause damage.

• Installation Condition
  The lift support must be installed in thefully extendedposition. Typically, the support cannot be compressed before installation. If you encounter any issues during installation, please contact us.Never force the support.

• Aligning the Ends
  If the ends of the support do not align with the ball studs, try rotating the body. First, attach therod end(the thinner end) of the support to the ball stud on the vehicle. Then, rotate thecylinder body(the thicker end) clockwise until the other end aligns with the corresponding ball stud.

---