* I have been selling these like hot cakes! I am again out of stock on swivels and should be back in by sept 21st. I’m very sorry for the delay. I did not realize these would be this hot of a seller*
Hertz Mille Pro MP70.3 Midrange pods WITH Swivel joint locking mounts up to 85 deg of range (unbeatable value)
This kit is perfect for getting the mids on axis for your seating setup! It is so versatile, you can mount it in many ways!
Optimized sizing for use with FACTORY GRILLS!!! Can also be used without grills too.
Comes with
- (2) pods
- (2) locking swivel joint mounts
- All mounting hardware
Made of heat treated glass fiber infused filament that is rated for 102+ degrees F ambient temp
*Nerd Facts*
Benefits of a composite pod
- ability to dissipate resonances as the material is damped very well compared to metal.
- For midranges and widebands, I optimize the internal structure to squeeze out internal volume, and to also dissipate additional standing waves while retaining a well structured housing.
- You can achieve special shapes like this thanks to additive manufacturing unlike subtractive manufacturing where you cannot achieve internal volume optimized shapes while retaining a smaller overall footprint without spending thousands on very expensive tooling.
- I take a high attention to detail on the exterior as well as the performance of the pod from a tonality standpoint as well.
I have tested this filament rigorously to withstand harsh conditions.
As a mechanical engineer and audiophile with experience in design, manufacturing, quality, and reliability engineering, I have utilized skills learned over the years to truly make a versatile product that works excellently!
-———— INSTALL TIPS—————
1. Find a flat point on the A pillar or sail panel to ensure proper seating of the washers can be achieved.
2. Use loc tite as much as possible
3. Use vice grips and a towel. Minor scratching may occur so please keep this in mind
4. There is a port like hole on the back of joint area of the stud and swivel. You can seal this up to prevent port noise from occurring, the frequency response will not be altered much as confirmed by RTA
5. Understand that you are liable for your own install as these are somewhat DIY oriented. It is easy to install but you must have a basic understanding of washers and tightening nuts. Please contact me if you need help! I can NOT accept returns for install issues as lots of customers and I have validated that they install properly.
Made in the USA!
Please note that with 3D printed products, cosmetic blemishes may occur but I strive to reduce these as much as I can and even reject poor appearance parts. With that being said, I will not be accepting returns as these are 3D printed components. Thank you for understanding but please also note that I have engineered these to perform as good as I can with extensive design work and real world testing.
Thanks,
Ash (AshGS400 on Diyma)
