Open box. The factory carton was opened before it reached us and is not sealed, but nothing is missing and the panel has never been installed.
Kemimoto sliding glass rear windshield for the Can-Am Defender, model B0110-15703-CL.
Fits Can-Am Defender HD5 (2017-2021), HD8 (2016-2021) and HD10 (2016-2021), including the Defender MAX and Defender Pro. Check the compatibility chart above against your own machine before buying.
5mm tempered safety glass in a steel frame, with a sliding vent panel, a water-guide drain hole and a rubber seal round the full perimeter. The glass is marked TEMPERED E000143, DOT-848 AS-2M-250 and ECE 43R-000127, with the Kemimoto logo screen-printed in the lower corner.
The complete mounting kit is included in its unopened factory bags: two fixed brackets, two of each clamp, rubber and composite washers, plastic cylinders, cushion washers, two R-type clamps, a spare EVA foam strip, M6 screws, flange and locking nuts, an Allen wrench and an open-end wrench. The printed product manual and the installation-tips sheet are both included. Kemimoto quotes a 15-minute install.
Condition: the glass has no chips, cracks or star marks, the perimeter seal is complete and unbroken, and the vent panel slides freely and latches shut.
A rear panel closes the back of the cab, which cuts the dust and exhaust an open cab pulls in behind you, and the sliding vent lets you dump heat without opening the machine up.
