Eliminate the guesswork. This reversible mount can be installed on BOTH the Driver or Passenger side. Whether you have a Standard or Low seat base, or run Factory or Aftermarket swivels, this mount is engineered to fit your setup.Product Overview: This sturdy, no-drill Lagun table mount fits 2007–2026 Mercedes Sprinter vans (NCV3 & VS30). It installs in minutes using existing factory holes in the seat base and the B-pillar D-ring bolt.It is precision-machined from two pieces of 0.25" raw 5052 aluminum. When your Lagun Mounting Bracket (not included) is bolted on, it ties the two pieces together to form a rigid, secure assembly that locks firmly between the seat base and the B-Pillar.Finish Note: The mount is sold with a Raw Aluminum / Orbital Finish. We treat the parts with a random orbital sander to create a uniform, matte industrial texture. However, this is a raw manufacturing component—it may bear machining marks. It is ready for you to paint, powder coat, or leave as-is for a rugged industrial look.Installation:Uses the factory D-ring bolt on the B-pillar.Uses the factory holes in the seat base.No drilling required. All necessary mounting hardware is included.Compatibility & RV Fitment:Reversible: Fits both Driver and Passenger sides.Seat Bases: Fits both Standard (High) and Factory Low (Option S87) Mercedes Sprinter seat bases. Swivels: Compatible with OEM swivels and most aftermarket swivels (Scopema, Alpine Mechanisms, Mobiframe etc.).RV / Class B Van Owners: Compatible with factory-built adventure vans such as the Winnebago Revel, Storyteller Overland, Jayco Terrain, Thor Tranquility, and Coachmen Galleria.CONFIGURATION GUIDE: Select Your MountSince this mount fits all Mercedes Sprinter seat bases, you only need to select the option that matches your Lagun Table hardware:1. Standard/Wide Lagun Bracket Select this if: You are using the Standard Lagun Mounting Bracket (approx. 3.5" wide).Note: This is the default bracket included with most new Lagun Table Systems.2. Narrow/Sliver Lagun Bracket Select this if: You are using the Lagun "Sliver" Mounting Bracket (approx. 1 3/16" wide).FITMENT VERIFICATION REQUIRED: Because RV builders often add custom trim, plastics, or upholstery over the seat bases, you must verify access before ordering:B-Pillar: You must have access to the factory D-Ring bolt at the bottom of the pillar.VS30 (2019–2026): If you have clear access to the two factory holes on the rear, outboard side of the seat base (closest to the B-Pillar), this is a 100% No-Drill installation.NCV3 (2007–2018): These models do not have factory holes in the seat base. Installation requires you to mark and drill your seat base.
What's Included:(1) 2-Piece Aluminum Mount Set(1) Hardware Pack (Bolts, Nuts, Washers)Note: The Lagun Table System itself is NOT included.Made in USA by Stoutlander.
