Scangauge III Mount for 4Runner and Tacoma by Spiker Engineering For Sale - New and Used

• Custom made mount to hold the Scangauge III in your ’96-02 4Runner or ’96-00 Tacoma

• Places the Scangauge III where you can see it without taking your eyes off the road and without obstructing your view

• Attaches securely to the A-pillar grab handle, and eliminates suction cups or tape that won’t stand up to off-roading

• Precision laser cut from heavy gauge cold rolled steel, and finished with flat black powder coat

• 100% USA Made

• Includes everything needed for installation: mounting bracket, strong magnet to hold the Scangauge III securely, high-strength socket head screw to replace original Phillips head grab handle screw if needed, and detailed illustrated instructions
  

• Not for use with Scangauge II (see separate listing)

• Scangauge is not included

• Note: to install this mount, you will need to remove the a-pillar handle Phillips screw. Early Toyota trucks had loctite applied to these screws, and may be difficult to remove. You may need a special JIS bit and impact driver, or (in rare cases) you may need to drill out of the screw. The instructions supplied with these mounts provide some tips on tools and techniques to help remove the screw. We recommend that you try to loosen the screw BEFORE placing your order, to make sure that you can get the screw out.

---